Positioning system DST-P / DSK-P.

This unit consists of a rectangular aluminium profile with 2 integrated rail guides. The carriage is driven by means of a rotating spindle with leading nut. Where two parallel linear units are used or where two carriages are mounted on one unit, the leading-nut receiver can be used to adjust the symmetry of the carriages. A special curved aluminium sheet is covering the carriage side. There is only a small gap between carriage and aluminium sheet. The cover profile can be adjusted according to the mounting position.

Spindle drives

Sizes: 120, 160, 200

Repeating accuracy:
Trapezoidal thread: ± 0.2 mm
Ball screw: ± 0.025 mm

Function:
This unit consists of a rectangular aluminium profile with 2 integrated rail guides. The carriage is driven by means of a rotating spindle with leading nut. Where two parallel linear units are used or where two carriages are mounted on one unit, the leading-nut receiver can be used to adjust the symmetry of the carriages. A special curved aluminium sheet is covering the carriage side. There is only a small gap between carriage and aluminium sheet. The cover profile can be adjusted according to the mounting position.

Fitting position:
As required, max. length DST/K 120P / 1600mm, DST/K 160P / 1800mm, DST/K 200P / 2000mm

Carriage mounting:
By tapped holes.

Unit mounting:
T-slots

Carriage support:
In the standard version, the carriage runs on 4 runner blocks which can be serviced at a central servicing position. For longer carriages the number of runner blocks can be increased.