WEISS Application Software W.A.S. 2.

Discover the consistent further development of the WEISS Application Software. Easy-to-use, intuitive and compatible with all WEISS automation components – even for complete multi-axis systems and LS 280 (W.A.S. 2 LS)

Intuitive operating concept: The stylish interface of W.A.S. 2 is available as a Windows program or via web interface for mobile devices.
Explore the systematic development of the WEISS Application Software. Easy, intuitive and for all WEISS automation components – even for complete multi-axis systems.

Plug & Work for individual or system modules
The new WEISS Application Software W.A.S. 2 lets you configure and control all your WEISS components with ease. Individually or in combination as a multi-axis system. All system combinations can be easily achieved: electro- or servo-mechanical rotary table with direct-drive rotary or linear units.

Maximum user friendliness
Whether via the Windows program, a web browser or on mobile devices, the interface is so simple and intuitive that in-depth control knowledge is not required for commissioning. Even manufacturers without their own software specialists will be able to set up the modules themselves.

Up to 30% more output
The various modules communicate directly with each other – without having to go through a higher-level control unit. This saves valuable processing time and the cycle rate of the entire system increases significantly. With high-speed applications, output increases by up to 30%.

Smart energy management
Other advantages include the various monitoring and diagnostic functions. And when it comes to energy: the W.A.S. 2 enables accurate energy analysis because consumption is measured and stored precisely down to the minute. There is even energy recovery with an active power supply.

WEISS APPLICATION SOFTWARE
. Control packages matched to the respective requirements are available: SCALABLE, COMPACT and LS
. All positions and speeds are freely programmable
. Free language selection
. Easy access to all axis parameters
. Diagnostic functions
. Inputs and outputs can be forced (e.g. for start-up)
. Alarm history
. Logbook
. Oscilloscope software

W.A.S. 2 LS
The W.A.S. 2 LS (WEISS Application Software for LS 280) program for Windows is for controlling the linear assembly system while also acting as the interface to the higher-level customer control system. In addition to the basic functionality for the start-up the software provides many further functions.
. Visualisation
. Free language selection
. Status bar for the single cells
. Display of alarm messages
. Easy access to parameter of the cells
. Inputs and outputs can be forced
. Monitoring functions
. Alarm history
. Diagnostic functions
. Ethernet connection to the control
. Load and display a parameter set “offline”

W.A.S. 2 SCALABLE
. 1 to 32 axes possible
. Large scope of functions, such as energy recovery
. Software cams
. Sequence programming
. PCM
. Friction measurement
. Easy to expand
. Configurable fieldbus telegrama

W.A.S. 2 COMPACT
. 1 to 4 axes possible
. Defined interfaces
. Small installation space